Sound level meter class I and II

For measurements for workplaces which are outdoors, e.g. at airports, on building sites, in road construction etc. with broad access to spectrum thanks to the highly-accurate 24-Bit A/D converter.

• Different sound pressure levels can be selected, such as, for example, Laeq, LcPeak, LaF, LaFMax, LaFMin, SD, SEL, E
• The optimised analogue frontend switch reduces the ambient noise and increases the linear measuring range
• Three profiles and 14 user-defined measurements can be calculated in parallel with different frequency and time weighting
• LN statistics and display of the graph showing the progression of time
• User-defined integral interval measurement up to a maximum of 24 hours is possible
• Frequency weighting (filter) A, B, C, Z
• Time interval during measurement: F (fast), S (slow), I (pulse)
• Freely-definable limits for the output of an optical alarm signal
• Peak Hold Mode to capture peaks
• Octavo function for targeted sound analysis
• Track function with graphic display of a measurement
• Calibration mode (with optional calibrator)
• Trigger mode: Analogue signal to switch the device on or off with 3.5 mm plug
• Automatic measurement for timer function is possible
• Measured value recording frequency selectable: 10, 5, 2 Hz
• Data transfer using MicroSD (4 GB), RS-232 or USB
• Option of fitting a column on the rear of the housing, ¼ thread

Scope of supply: Sound level meter, memory card, hard carrying case

• Specifications SW 1000 // SW 2000
• Measuring capacity linear: 20 … 134 dB // 25 … 136 dB
• Frequency range: 0,003 … 20 kHz // 0,02 … 12,5 kHz
• Sensitivity: 50 m V/Pa // 40 m V/Pa